In diesem Band geht es um optische Bauelemente aus Kunststoff, die mithilfe von Spritzgussverfahren hergestellt werden. Abgedeckt werden Fragen des Designs und der Produktionstechnologie bis hin zur Qualitätskontrolle. Ein unentbehrlicher Praxishelfer für alle, die in der optischen Forschung und Entwicklung arbeiten.
Inhoudsopgave
Chapter 1: Introduction
Dr. Stefan Bäumer
Chapter 2: Optomechanics of plastic optical components
Prof. Dr. Michael Pfeffer
Chapter 3: Tooling
Thomas Bauer / Marshall
Chapter 4: Metrology of injection molded optics
Dr. Stefan Bäumer
Chapter 5: Optical Plastics
Zeon Corporation
Chapter 6: Coating on Plastic
Dr. Ulrike Schulz
Chapter 7: Injection molding Equipment & Process
Dr. Thomas Walter
Chapter 8: Cost model of injection molded optics
Jukka-Tapani Mäkinen
Chapter 9: Applications
Dr. Stefan Bäumer
Over de auteur
Stefan Bäumer studied physics at the University of Bonn, Germany, and Washington State University, where he received his Master of Science degree in 1988. He subsequently returned to Germany to finish his Ph.D. degree at the Institute of Optics of the Technical University Berlin in 1995. Since then he has been working in several positions for Philips in Eindhoven, The Netherlands. Dr. Bäumer currently holds the post of senior optical systems designer at Philips Applied Technologies. His work focuses on optical systems design with a specialization in plastic optics, involving close cooperation with injection molding companies.
Meer e-boeken van dezelfde auteur (s) / Editor
986 E-boeken in deze categorie
