This volume presents research papers on unconventional machining (also known as non-traditional machining and advanced manufacturing) and composites which were presented during the 7th International and 28th All India Manufacturing Technology, Design and Research conference 2018 (AIMTDR 2018). The volume discusses improvements on well-established unconventional machining processes and novel or hybrid machining processes as well as properties, fabrication techniques and machining of composite materials. This volume will be of interest to academicians, researchers, and practicing engineers alike.
İçerik tablosu
Powder Mixed Near Dry Electric Discharge Machining Parameter Optimization for Tool Wear Rate.- Comparative Study of Dielectric and Debris Flow in Micro Electrical Discharge Milling Process using Cylindrical and Slotted tools.- Parametric Investigation into Electrochemical Micromachining for Generation of Different Micro-surface Textures.- Investigations into Wire Electrochemical Machining of Stainless Steel.- Nanofinishing of External Cylindrical Surface of C60 Steel Using Rotating Core Based Magnetorheological Finishing Process.- Effect of Laser Parameters on Laser Induced Plasma Assisted Ablation (LIPAA) of Glass.- An Experimental Study of Electro-Chemical Spark Drilling (ECSD).- Development and Experimental Study of Ultrasonic Assisted Electrical Discharge Machining Process.
Yazar hakkında
M.S. Shunmugam is a Professor (Emeritus) in the Manufacturing Engineering Section in the Department of Mechanical Engineering, Indian Institute of Technology (IIT) Madras. After receiving his Ph D in Mechanical Engineering from IIT Madras in 1976, he has worked in IIT Bombay (from 1977 to 1980) and in IIT Madras from 1980 onwards. He was a visiting faculty member at Michigan Technological University during 1989-1991 and was a member in the board of governors of IIT Madras during 2012-2013. Dr. Shanmugam’s research interests include metrology, machine tools, manufacturing, gears, micro-machining and computer applications in manufacturing. He has published about 130 peer-reviewed international journal papers, 15 peer-reviewed national journal papers, 75 international conferences and about 80 national conferences.
M. Kanthababu is a Professor in the Department of Manufacturing Engineering in Anna University, Chennai, Indiaand the Director of the Centre for Intellectual Property Right and Trade Marks in Anna University. He has completed his MS in Mechanical engineering and Ph D in Advanced Manufacturing Technology from IIT Madras. Prof Kanthababu’s research interests include manufacturing technology, composite materials and machining, and automation in manufacturing. He has published more than 30 peer reviewed international journal papers and 2 books, and holds one patent.
Aynı yazardan daha fazla e-kitap / Editör
16.400 Bu kategorideki e-kitaplar
