Activated tungsten inert gas welding process involves a method of increasing penetration capability of the arc in TIG welding. This is achieved through the application of a thin coating of activated flux onto the joint surface prior to welding. This leads to strong joint. This paper deals with the study of microstructural and mechanical properties of aluminium alloy AA-6061 weld joints using A-TIG welding. During the experiment the welding current and gas flow rate are used as variable parameters and welding speed kept as constant. In this activated TIG welding process, there were five single component fluxes which are Cd Cl2, Si O2, Mg O, Al2O3 and Ti O2 used in the initial experiment to evaluate Welding current, Gas Flow Rate, Flux by joining plates by using A-TIG welds. Based on the higher penetration of weld bead, two single component fluxes Si O2 and Ti O2 were selected for actual experiment. The values of optimum welding current and gas flow rate and flux was finding out from the experiment. Welding specimen were investigated using scanning electron microscope, vicker's micro hardness test and tensile strength. The Si O2 flux produced the most noticeable effect in terms of tensile strength and micro hardness.
Thêm sách điện tử từ cùng một tác giả / Biên tập viên
99.335 Ebooks trong thể loại này
